Some HypnoOrb Progress

While my latest round of HypnoOrb progress hasn’t yet resulted in another fully functional design, it’s a good step in that direction. I’ve been learning to make good use of Cadsoft’s free version of their PCB design tool called Eagle. At this point I’ve been kind of stuck on getting the path of the wires routed well. The free version of Eagle provides some routing features, but I’m told it’s best to go with some other tools, tools that I’m pretty sure cost the GDP of a small nation, or possibly continent. But fear not, this is a fairly simple board, so I think worst case I should be able to manually route it in a very awesome way…. I hope. Anyway, below’s an image of the latest layout I’ve got…

HypnoOrb Prototype MK3
HypnoOrb Prototype MK3

Arduino Independence

Getting the Arduino Processor to function on a breadboard

The next step in my HypnoOrb project is to figure out how to get the Arduino microprocessor (AKA ATMega168) that makes the whole thing work function with as little hardware as possible. Thanks to this awesome site, I found, I now know what I wasn’t doing right before finding that document. I hope making a reference to that helpful tutorial here will help others find it faster than I did. Have fun!

Arduino Processor on a breadboard
Arduino Processor on a breadboard

Arduino on a Breadboard
RGB LEDS under a bag